Panasonic Lumix S1H

10. Recording Videos
269
[Time Code
Value]
[Reset]
Sets to 00:00:00:00 (hour: minute: second:
frame)
[Manual Input] Manually input hour, minute, second and frame.
[Current Time]
Sets hour, minute and second to current time
and sets frame to 00.
[Time Code
Mode]
[DF]
Drop Frame. The camera modifies the
difference between recorded time and time
code.
0 Seconds and frames are separated by “.”.
(Example: 00:00:00.00)
[NDF]
Non-Drop Frame. Records the time code
without drop frame.
0 Seconds and frames are separated by “:”.
(Example: 00:00:00:00)
0 When the following functions are being used, [Time Code Mode] is
fixed to [NDF]:
– [50.00Hz (PAL)]/[24.00Hz (CINEMA)] ([Synchro Scan])
– 47.95p or 23.98p [Rec Quality]
[HDMI Time
Code Output]
Time code information is added to images output via HDMI when
recording with the [ ] mode.
0 The time code can also be output via HDMI by setting the mode
dial to [ ] during playback. In the [Setup] ([IN/OUT]) menu, set
[HDMI Mode (Playback)] in [TV Connection] to [AUTO]. (l 451)
0 The device screen may go dark depending on the connected
device.
[External TC
Setting]
0 Synchronise the time code default value with an external device
that supports time code input and output. (l 270)
[TC
Synchronization]
Selects the input (l 273) and output (l 271) for
time code signals.
[TC Output
Reference]
Sets the timing for time code signal output.
(l 271)