17. Connecting to Other Devices
532
By connecting the camera to a Panasonic Blu-ray disc recorder or DVD
recorder, you can store the pictures and videos.
Getting started:
0 Turn on the camera and recorder.
0 Insert a card into card slot 1.
1
Connect the camera and recorder with the USB
connection cable (C–C or A–C). (l 522)
2
Press 34 to select [PC(Storage)] and then press or
.
0 A message about charging may be displayed. Wait for a while until the
message disappears.
3
Operate the recorder to store the images.
Storing on a Recorder
0 If [USB Mode] is set to [PC(Storage)] in the [Setup] ([IN/OUT]) menu, the
camera will be automatically connected to the recorder without the [USB
Mode] selection screen being displayed. (l 449)
0 Take care not to turn off the camera while storage is in progress.
0 Images such as 4K videos may not be supported depending on your recorder.
0 Turn off the camera and disconnect the USB connection cable before
removing the card from the camera. Otherwise, the recorded data may be
damaged.
0 For the storage and playback procedures, refer to the operating instructions
for the recorder.
To Next Page
Loading...
