Panasonic Lumix S1H

10. Recording Videos
270
Synchronise the time code default value with an external device that
supports time code signal input and output.
A Flash synchro socket
B BNC conversion cable (for TC IN/OUT) (supplied)
C BNC cable (commercially available)
D External devices

Preparations for Time Code Synchronisation
When [Count Up] is set to [FREE RUN] in the [ ] mode, you can
synchronise the initial value of the time code with an external device.
1
Set the mode dial to [ ].
2
Set [Count Up] to [FREE RUN].
0
¨ [ ] ¨ [ ] ¨ [Time Code] ¨ [Count Up] ¨ [FREE RUN]
3
Rotate the flash synchro socket cap in the
direction of the arrow to remove.
0
Be careful not to lose the flash synchro socket
cap.
Synchronising the Time Code with an
External Device