Panasonic Lumix S1H

10. Recording Videos
272
3
Set [TC Synchronization] to [TC OUT].
≥ ¨ [ ] ¨ [ ] ¨ [Time Code] ¨ [External TC Setting] ¨ [TC
Synchronization]
¨ [TC OUT]
≥The time code signal is output according to the recording frame
rate of the [Rec Quality] and the [Time Code Mode] ([DF]/[NDF])
setting.
4
Operate the external device to synchronise the time
code.

Outputting the Time Code Signal Again
By setting as follows, the time code signal (LTC signal) can be output just
by connecting with the external device with the BNC cable:
– [ ] mode
– [Count Up] ([Time Code]): [FREE RUN]
– [TC Synchronization] ([External TC Setting] in [Time Code]): [TC OUT]