Panasonic Lumix S1H

2. Getting Started
49

Card Access Indications
The card access light turns on while the
card is being accessed.

Removing a Card
1
Open the card door.
0
Check that the card access light A is
turned off and then open the card door.
2
Push the card until it clicks and then
pull the card out straight.
0 You can set the way to record to card slots 1 and 2:
[] ¨ [ ] ¨ [Double Card Slot Function] (l 92)
0 The card may be warm just after the camera has been used. Be careful when
removing.
0 Do not perform the following operations during access.
The camera may operate incorrectly or the card and recorded images
may be damaged.
– Turn off the camera.
– Remove the battery or card or disconnect the power plug.
– Subject the camera to vibration, impacts, or static electricity.
0 You can set so that the card access light does not turn on:
[] ¨ [ ] ¨ [Card Access Light] (l 452)