Panasonic PT-REQ15 - Page 254

Chapter 5 Operations — Using the web control function
254 - ENGLISH
[Crestron tools]
Set the information required for connecting the control system of Crestron Electronics, Inc. to the projector, and
the information to monitor/control the projector using the control system of Crestron Electronics, Inc.
When the [NETWORK] menu → [NETWORK CONTROL] → [Crestron Connected
TM
] is set to [OFF], the [Crestron
tools] cannot be set.
Click [Network menu] → [Crestron tools].
To update the settings, click [Save].
r [Control System]
Congure the setting for the control system required to connect to the projector as a client.
1
2
3
4
5
6
7
8
9
1 [Use TLS]
Set the secure communication.
[Disable]:
Performs the unsecured communication.
[Enable]:
Performs the secure communication using TLS (Transport
Layer Security).
2 [IP Address / Hostname]
Enter the IP address or the host name of the connection
destination.
3 [IP ID]
Set the IP ID used to determine the projector on the network. (A
number up to four digits)
Default value: 3
4 [Room ID]
Set the Room ID used to determine the projector on the
network. (Up to 32 half-width characters)
5 [Non Secure Port]
Set the port number to be used with the unsecured
communication.
Default value: 41794
6 [Secure Port]
Set the port number to be used with the secure communication.
Default value: 41796
7 [Authentication]
Select the authentication with the connection destination used
with the secure communication.
[Disable]:
Does not perform the connection authentication.
[Enable]:
Performs the connection authentication.
8 [User Name]
Enter the user name used for the connection authentication.
(Up to 20 half-width characters)
9 [Password]
Enter the password used for the connection authentication. (Up
to 20 half-width characters)