Panasonic PT-RQ25K Series - Page 129

Chapter 4 Settings — [ADVANCED MENU] menu
ENGLISH - 129
17) Press the <ENTER> button.
f The adjustment area in the projected image becomes temporarily bright and the [NON-OVERLAPPED
BLACK LEVEL] screen is displayed.
f [RED], [GREEN], and [BLUE] can be adjusted individually if [INTERLOCKED] is set to [OFF].
18) Press as to select an item, and press qw to adjust the setting.
f Once the adjustment is completed, press the <MENU> button to return to the [BLACK LEVEL ADJUST]
screen.
19) Press as to select [UPPER WIDTH], [LOWER WIDTH], [LEFT WIDTH], or [RIGHT WIDTH] in [BLACK
BORDER AREA].
20) Press qw to set the standard width of [BLACK BORDER AREA].
21) Press as to select [UPPER FREE SHAPE], [LOWER FREE SHAPE], [LEFT FREE SHAPE], or [RIGHT
FREE SHAPE].
22) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
Select this item when the shape of the border between [NON-OVERLAPPED BLACK LEVEL] and
[BLACK BORDER LEVEL] is not to be adjusted.
The region of the rectangle with the standard width set in Step 20) will be the [BLACK BORDER
AREA].
[ON]
Select this item when the shape of the border between [NON-OVERLAPPED BLACK LEVEL] and
[BLACK BORDER LEVEL] is to be adjusted.
f Proceed to Step 30) when [OFF] is selected.
23) Press the <ENTER> button.
f The [UPPER FREE SHAPE] screen, the [LOWER FREE SHAPE] screen, the [LEFT FREE SHAPE]
screen, or the [RIGHT FREE SHAPE] screen is displayed.
24) Press as to select [ADJUSTMENT POINTS].
25) Press qw to switch the item.
f The items will switch each time you press the button.
[2] Adjusts the shape of the border at points on both ends.
[3] Adjusts the shape of the border at three points
*1
.
[5] Adjusts the shape of the border at ve points
*1
.
[9] Adjusts the shape of the border at nine points
*1
.
[17] Adjusts the shape of the border at 17 points
*1
.
*1 The points are not placed at equally spaced intervals.
26) Press as to select [EXECUTE].
27) Press the <ENTER> button.
f The projector will go into the adjustment mode.
28) Press asqw to select the adjustment point.
f Move the marker over to the point to adjust.
f Press qw to select the adjustment point when [UPPER FREE SHAPE] or [LOWER FREE SHAPE] is
selected in Step 21).
f Press as to select the adjustment point when [LEFT FREE SHAPE] or [RIGHT FREE SHAPE] is selected
in Step 21).
29) Press asqw to adjust the position of the adjustment point.
f Press as to adjust [VERTICAL] when [UPPER FREE SHAPE] or [LOWER FREE SHAPE] is selected in
Step 21).
f Press qw to adjust [HORIZONTAL] when [LEFT FREE SHAPE] or [RIGHT FREE SHAPE] is selected in
Step 21).
f By adjusting the position of the adjustment point, the border between the adjacent adjustment point will be
interpolated by a straight line.
f To continuously adjust the positions of other adjustment points, return to Step 28).