Chapter 4 Settings — [SECURITY] menu
ENGLISH - 217
f When [INPUT SELECT BUTTON] is selected in Step 7), the item that can be set varies depending on the
selected button.
Refer to “Item that can be set with [INPUT SELECT BUTTON]” (x page 217) for details.
Once the switching of the item is completed, press the <MENU> button to return to the [CONTROL PANEL]
screen or the [REMOTE CONTROL] screen.
9) Press as to select [APPLY], and press the <ENTER> button.
f The conrmation screen is displayed.
10) Press qw to select [OK], and press the <ENTER> button.
Note
f When a button operation is performed on the device set to [DISABLE], the [CONTROL DEVICE PASSWORD] screen is displayed.
Enter the control device password.
f The [CONTROL DEVICE PASSWORD] screen will disappear when there is no operation for approximately 10 seconds.
f If the operations of both [CONTROL PANEL] and [REMOTE CONTROL] are set to [DISABLE], the projector cannot be turned off (cannot
enter standby).
f When the setting has completed, the menu screen will disappear. To operate continuously, press the <MENU> button to display the main
menu.
f Even when you set button operations on the remote control disabled, operations of the <ID SET> and <ID ALL> buttons on the remote
control are kept enabled.
Item that can be set with [INPUT SELECT BUTTON]
When [INPUT SELECT BUTTON] is selected in Step 7) of “Enabling/disabling any button” (x page 216), the
item that can be selected varies depending on the button to set.
The item that can be selected when each button is set is as follows.
r [HDMI1/2 BUTTON]
[TOGGLE]
Switches the items in following order when the button is operated.
[HDMI1] → [HDMI2]
[HDMI1] Fixes to selection operation of the HDMI1 input.
[HDMI2] Fixes to selection operation of the HDMI2 input.
[DISABLE] Disables button operations.
r [HDMI BUTTON]
[TOGGLE]
Switches the items in following order when the button is operated.
[HDMI1] → [HDMI2]
[HDMI1] Fixes to selection operation of the HDMI1 input.
[HDMI2] Fixes to selection operation of the HDMI2 input.
[DISABLE] Disables button operations.
Note
f [SDI BUTTON] can be selected when the optional 12G-SDI Terminal Board (Model No.: TY-SB01QS) is installed in the slot.
f [DIGITAL LINK BUTTON] can be selected when the optional DIGITAL LINK Terminal Board (Model No.: TY-SB01DL) is installed in the slot.
f [SDI BUTTON] and [SLOT1 BUTTON] can be selected when the Function Board is installed in the slot.
To Next Page
Loading...
