Panasonic PT-RQ25K Series

Chapter 5 Operations — Using the information monitor function
284 - ENGLISH
4) Press the <ENTER> button.
f The detailed item is displayed.
f The network selection item is displayed when [NETWORK] is selected in Step 3). Proceed to Step 6).
5) Press as to switch the item.
f The display items will switch each time you press the button.
Sub-menu item Detailed item Details
[PROJECTOR]
[PROJECTOR ID] Displays the ID number set to the projector.
[PROJECTOR TYPE] Displays the type of the projector.
[SERIAL NUMBER] Displays the serial number of the projector.
[CONSOLIDATED RUNTIME]
Converts the total runtime of the light sources with [OPERATING
MODE] set to each item into the time used with the [NORMAL]
setting.
The consolidated runtime is used for a rough indication about when
to perform maintenance when the projector is used in combination
of each item in [OPERATING MODE].
[PROJECTOR RUNTIME] Displays the runtime of the projector.
[LIGHT RUNTIME] Displays the runtime of the light source.
[INTAKE AIR TEMP.] Displays the intake air temperature status.
[EXHAUST AIR TEMP.] Displays the exhaust air temperature status.
[SELF TEST]
Displays the self-diagnosis information.
Displays the detailed information when the <ENTER> button is
pressed while error/warning has occurred.
[INPUT]
Displays the currently selected input.
Displays the representative input terminal when one image is
displayed with multiple input signals.
[SIGNAL NAME] Displays the input signal name.
[ON SCREEN DISPLAY]
Displays the status of on-screen display function. ([ON]: Display;
[OFF]: Hide)
[SHUTTER]
Displays the status of the shutter. ([CLOSE]: Shutter function
enabled; [OPEN]: Shutter function disabled)
[FREEZE]
Displays the status of the freeze function. ([ON]: Paused; [OFF]:
Cleared)
[REMOTE2 STATUS] Displays the control status of the REMOTE2.
[AC VOLTAGE] Displays the input supply voltage.
[OPERATING MODE]
Displays the setting value of the [PROJECTOR SETUP] menu →
[OPERATION SETTING] → [OPERATING MODE].
[MAX LIGHT OUTPUT LEVEL]
Displays the setting value of the [PROJECTOR SETUP] menu →
[OPERATION SETTING] → [MAX LIGHT OUTPUT LEVEL].
[LIGHT OUTPUT]
Displays the setting value of the [PROJECTOR SETUP] menu →
[LIGHT OUTPUT].
[INFO MONITOR]
[DEFAULT]
Displays the display setting of the information monitor during normal
status. ([USER VIEW]: Display; [OFF]: Hide)
[INPUT]
Displays the display status of each item during the USER VIEW
mode. ([ON]: Display; [OFF]: Hide)
[SIGNAL NAME]
[AC VOLTAGE]
[INTAKE AIR TEMP.]
[EXHAUST AIR TEMP.]
[SHUTTER]
[FREEZE]
[OSD]
[IP ADDRESS(WIRED)]
[DIRECTION]
Displays the direction of the text to display in the information
monitor. ([AUTO]: Automatic detection; [NORMAL]: Floor mount;
[FLIPPED]: Inverted upside down)
[BRIGHTNESS]
Displays the setting value of the [PROJECTOR SETUP] menu →
[INFO MONITOR SETTING] → [BRIGHTNESS].
[VERSION] [FIRMWARE VERSION] Displays the rmware version of the projector.
6) Press as to switch the item.
f The display items will switch each time you press the button.
[PJ NAME] Select this item when [PROJECTOR NAME] is to be displayed.