Parker Hannifin
- 2 - Aries Controller Hardware Installation Guide
Aries Controller—Overview
The Aries Controller is a single-axis drive/controller based on the Aries drive
platform. Setup and programming is accomplished using the AcroBASIC
language within the ACR-View programming environment.
Aries Controller Product Description
The Aries Controller is a single-axis digital servo drive with controller
capability. The drive closes position, velocity, and torque loops, receiving its
position setpoints from an internal servo controller. ACR-View is used to
configure and program the Aries Controller. There are three models with a
maximum continuous shaft power of 400, 750, or 1300 watts.
Aries Controller Part Numbers
The following diagram explains the Aries Controller part numbers:
Drive Type...............................................Aries
Maximum Shaft Power............................04 = 400W
08 = 750W
13 = 1300W
Command Interface ................................ C = Controller
Motor Feedback ...................................... E = Encoder
Input Power Level
Motor Input Power
AR-04CE, AR-08CE, AR-13CE ..............120/240 VAC single-phase mains
motor input power
Control Input Power
AR-04CE, AR-08CE, AR-13CE ..............120/240 VAC single-phase mains
control input power
AR – 04 C E
To Next Page
Loading...
