Parker Hannifin
Chapter 3 Electrical Installation - 15 -
System Installation Overview
This section details the components and configuration necessary for
electrical installation of all models of the Aries Controller.
Installation of a motion control system requires an Aries Controller, a
compatible motor (listed on page 4), and access to a computer. See Figure 6
for a diag
ram of this system.
Figure 6 System Installation Overview
Warning — This product has been developed for industrial environments. Due to
exposed high voltage terminals, this product must not be accessible to users
while under normal operation.
Important — An R-clamp must be connected to the drive and snugly
attached to the exposed braided shield of the motor cable in order to control
electrical noise.
To Next Page
Loading...
