Parker Aries AR-04CE - Fault Correction; Table 30 Drive Status Indicator LED Descriptions

Parker Hannifin
- 72 - Aries Controller Hardware Installation Guide
Drive/Controller Status LED Illumination States
LED Left LED Right Description
Drive/Controller Enabled
Off
Green
Enabled
Yellow (flashes during
Regeneration)
Green
Enabled, Regeneration active
Yellow/Green (alternating)
Green
Enabled, Autorun mode
Drive/Controller Disabled
Off
Red
Disabled, no faults or
Ethernet boot, 8-second
process
Yellow Off
Motor control boot, 4-second
process
Yellow
Red
Disabled, no bridge power
Yellow & 1 Green (flashing) Red Disabled, Bridge fault
Yellow & 2 Green (flashing) Red
Disabled, Feedback fault
(Hall error or Encoder loss)
Yellow & 3 Green (flashing) Red Disabled, Thermal fault
Yellow & 4 Green (flashing) Red
Disabled, other fault
(Undervoltage, Overvoltage,
Motor Configuration error,
Motor Regeneration fault, or
Network Loss fault)
Yellow & 5 Green (flashing) Red
Disabled, Drive Parameter
fault
Table 30 Drive Status Indicator LED Descriptions
Fault Correction
To access further information on the drive status and fault conditions, use
ACR-View on the computer system connected to your Ethernet network.
1. Open a terminal connection to the drive using one of the methods
described under Terminal Emulator (Hyper Terminal) on page 70.
2. Enter
the DRCONFIG command to see a list of drive configuration
editors.
3. Enter the DRERROR command to see a list of drive error messages.
Pay particular attention to faults that need to be fixed. Refer to Table 31 for
corre
ctive action suggestions.