Parker TPDM - Page 107

Parker Hannifin Manufacturing Srl user’s manual TPDM
106
Par.
Description
Field
Def.
b180.10
Electronic CAM2 engaging on master phase 0.
W
0
b180.11
Electronic CAM2 release on master phase 0.
W
0
b180.12
CAM 2 engaging immediately (Signal lock/Unlock CAM 2).
R
0
b180.13
Electronic CAM2 execution on single shot.
W
0
b180.14
(0)Caught quota master frequency input (1) Caught quota
Motor position-Storage in Pr58:59.
W
0
b180.15
Enable swap table (engage/release linear).
W
0
b181.0
Enabled Tab.0 in the Cam. =1 TAB0 is enabled.
R
0
b181.1
Enabled Tab.1 in the Cam. =1 TAB1 is enabled.
R
0
b181.2
Enabled Tab.2 in the Cam. =1 TAB2 is enabled.
R
0
b181.3
Enabled Tab.3 in the Cam. =1 TAB3 is enabled.
R
0
b181.4
Command swap of Tab.3 (Tab.3-Tab1-Tab.0). The switching
between the tables is showed in the picture.
The switching starts from TAB3 to TAB0, clockwise direction.
W
0
b181.5
Command swap of Tab.0 ( Tab.0-Tab2-Tab.3). The switching
between the tables is showed in the picture.
The switching starts from TAB3 to TAB0, counterclockwise
direction.
W
0
b181.6
Selection Table in the CAM 2. The state of this bit, together with
bit b181.7, identifies the selected table (see table below*).
W
0
b181.7
Selection Table in the CAM 2. The state of this bit, together with
bit b181.6, identifies the selected table (see table below*).
* Table selection
b181.6
b181.7
Tab0
1
1
Tab1
1
0
Tab2
0
1
Tab3
0
0
W
0
b181.8
Enable virtual table (Tab.3).
W
0
b181.9
Enable counter position from CAM1 to global counter
(Pr131:130). This command, b181.9=1, enable the reference of
CAM1. This value is added algebraically to global counter of
reference.
W
0
b181.10
Enable counter position from CAM 2 to global counter (
Pr131:130). This command, b181.10=1, enable the reference of
positioner. This value is added algebraically to global counter of
reference.
W
0
b181.11
Enable counter position from trapezoidal positioner to global
counter (Pr131:130). This command, b181.11=1, enable the
reference of CAM2. This value is added algebraically to global
counter of reference.
W
0
b181.13
Enable counter position from CAM 1 to reference position
(Pr60:61).
W
0
b181.14
Enable counter position from CAM 2 to reference position
(Pr60:61).
W
0
b181.15
Enable counter position from trapezoidal positioner to reference
position (Pr60:61).
W
0