4. To prevent accidents, never bring any part of your fingers,
hair and clothes near the machine pulley, V belt, motor pulley,
thread take-up and needle bar. Also never leave scissors,
tweezers, tools, etc. around these areas.
5.Always turn off the power while the machine is not used or
before leaving the machine table.
6.In the event of a power failure, be sure to turn off the power.
7.While operating the machine, wear clothes that cannot be
caught in the machine.
8. Do not put any tools or other unnecessary objects on the
machine table while running the machine.
CAUTION
Maintenance, Check, Repair
1.Well trained operators and technicians are allowed to perform
maintenance, check and repair of the machine after studying
these precautions and the instruction manual carefully.
2. If it is necessary to lay the machine backward for
maintenance, check and repair, always turn off the power,
unplug the machine and press the treadle to make sure that
the machine dose not operate before beginning any of the
procedures.
3. Before installing/removing the V belt, always turn off the
power, unplug the machine and press the treadle to make sure
the machine does not operate.
4.Carry out daily maintenance work and periodical inspections
properly by following these precautions and the instruction
manual.
5.Employ Pegasus’ genuine parts when repairing the machine
and/or replacing the parts. We are not responsible for accidents
caused by any improper repair/adjustment and substituting
other parts for thoes manufactured by Pegasus.
6.Do not attempt to modify the machine at your own discretion.
We are not responsible for accidents caused by the
modification.
7.Be sure to replace the safety devices and/or safety covers that
are temporarily removed for maintenance and/or adjustment.
8.After performing maintenance, check and repair, make sure that
turning on the power does not pose any danger to you.
To Next Page
Loading...
