15192 Triton Lane
Huntington Beach, CA 92649
Office Tel: 714-892-3400
Hotline Tel: 714-891-6533
www.ppedm.com
This document is the property of PPedm Corp. and contains proprietary and/or patented information and may not be reproduced in
part or in whole without the express written permission of the company. Perfect Point logo, Perfect Point
TM
and E-Drill
®
are
trademarks of PPedm, Corp. US and worldwide patents pending.
No cutting occurs, vacuum
pump does not start.
Electrode needs replacement.
Green light on hand-tool is
flashing.
Replace electrode (see
Section 2.1).
System error. Flashing red
light on hand-tool.
Observe error displayed on
control terminal. Check water
level. Contact the PPedm
Customer Service Hotline for
support.
Hand-tool not connected to
utility cabinet.
Recheck hand-tool connection
on rear of cart. Ensure locking
bezel is fully rotated.
No cutting occurs, vacuum
pump starts but pressure
pump does not start.
Fastener surface is not
conductive.
Check that nose of hand-tool
is placed over fastener, and all
paint or sealant has been
removed from fastener
surface.
CG Hand Tool will not cut.
Ground pin incorrectly
adjusted or damaged.
EG Hand Tool will not cut
Check for bad or loose ground
clamp connection.
Cutting occurs but system
shows red warning LED at end
of cut.
Hand-tool trigger was released
prematurely.
Re-cut fastener ensuring to
hold down trigger until system
finishes cutting.
Cutting process ended
prematurely.
Check library setting for
correct fastener type. Make an
additional cut by squeezing
trigger a second time while still
in-place over fastener. The
system will likely repeat the
same error since less cutting
was required in the second
cycle.
To Next Page
Loading...
