Perfect Point E-Drill - Page 76

15192 Triton Lane
Huntington Beach, CA 92649
Office Tel: 714-892-3400
Hotline Tel: 714-891-6533
www.ppedm.com
User Guide
Document No.
61-101
Revision:
107
Date:
10/18/2018
This document is the property of PPedm Corp. and contains proprietary and/or patented information and may not be reproduced in
part or in whole without the express written permission of the company. Perfect Point logo, Perfect Point
TM
and E-Drill
®
are
trademarks of PPedm, Corp. US and worldwide patents pending.
Page 76 of 76
E-Drill General Fault
Trouble
Probable Cause
Remedy
Fastener does not punch out.
Wrong fastener settings.
Check all settings in the HHT.
Wrong electrode type.
Check electrode application
against fastener application.
Insufficient cut depth
programmed in HHT library.
Check fastener size.
Oversize fastener.
If problem persists, contact
PPedm Customer Service
Hotline for assistance.
User Error
User lifted hand-tool during cut
sequence.