5–5
ABS (Anti-lock Braking System)
warning light
This light will go on when the ignition switch is
turned “ON” and goes out a few seconds later.
The following conditions indicate that the
ABS (Anti-lock braking system) is possibly
malfunctioning.
• When the ignition switch is turned “ON”,
the light fails to go on or remains in an
illuminated state.
• After the light has extinguished, it lights
up again.
• The light illuminates while driving.
Have the system checked by an authorised
Perodua Service Centre immediately.
w WARNING
If the ABS warning light and the brake
warning light remains illuminated and
turn off, there is a possibility that the
braking force would drop drastically.
Immediately stop your vehicle at a
safe place and contact an authorised
Perodua Service Centre.
CAUTION
When the ABS warning light and the
brake warning light turns on at the same
time, the anti-lock brake system may
be malfunctioned. In addition, there is
a possibility that the vehicle becomes
unstable when hard braking is applied.
Immediately park your car at a safe place
and contact an authorised Perodua Service
Centre.
Malfunction indicator light (MIL)
If the engine electronic control system
malfunction while the engine is running, the
MIL goes on or blinks.
CAUTION
If the MIL goes on, immediately have the
vehicle checked by an authorised Perodua
Service Centre.
Sect 05_EN D42L.indd 5 04/11/2019 10:42 AM
To Next Page
Loading...
