10–1
Before starting engine
1. Perform the pre-starting check.
See Section 13.
2. Check the safety around the vehicle
before entering it.
3. Make sure that the parking brake is
applied.
4. Adjust seat position, seatback angle, and
headrest height.
5. Adjust the inside mirror and outside
mirrors.
6. Fasten seat belts.
7. Turn off unnecessary lights and
accessories.
8. Check fuel gauge if fuel is enough to
drive.
Starting engine
CAUTION
• Do not crank the starter continuously
for more than 10 seconds.
• Do not race a cold engine to prevent
engine from damage.
• Keep moderate speed until the engine
warms up thoroughly.
• Make sure that you are seated in the
driver seat before starting the engine.
Do not start the engine from the
outside of the vehicle. Your car may
unexpectedly move while turning the
ignition switch.
• Do not accelerate the vehicle when the
engine coolant temperature is low.
Floor mat
Fastener
Floor mat
Before driving, make sure that the floor mat is
installed securely in correct position.
w WARNING
When using a floor mat, arrange it
properly to ensure it will not interfere
with the free movement of the brake
pedal or acceleration pedal. Do not
stack more than one floor mat.
Secure the floor mat in place, using
the special fasteners. (If equipped)
Failure to observe this warning may
cause the brake pedal or accelerator
pedal to get stuck on the floor mat,
leading to accidents.
Sect 10_EN D42L.indd 1 07/11/2019 8:26 AM
To Next Page
Loading...
