10–12
w WARNING
• When parking or stopping your
vehicle, make sure that there is
no combustible objects such
as dry grass and oil around
and underneath your vehicle.
The exhaust pipe may reach an
extremely high temperature, and it
is possible that nearby combustible
objects may be ignited.
• When you park the vehicle, engage
the parking brake fully except when
the mechanism could be frozen.
Place the manual transmission
lever in 1st on the uphill grade or
reverse on the downhill grade, or
the automatic transmission lever
in P.
Parking tips
1. Make sure that your vehicle has completely
stopped.
2. Depress the clutch pedal and shift the
transmission lever to neutral (manual
transmission).
3. Press the brake pedal and shift the lever
to P (automatic transmission).
4. Apply parking brake.
5. Turn the ignition switch to “OFF” or “LOCK”
then pull out the key.
CAUTION
• Do not forget to apply parking brake.
• Do not leave your vehicle while the
engine is running.
• When leaving your vehicle, make sure
that you set the ignition switch to “OFF”
or “LOCK” and pull out the key to avoid
battery from being discharged.
• For automatic transmission:
• While parking, make sure that the
transmission lever is at P because
at this range, all tyres are locked.
• Do not shift the lever to P until your
vehicle is completely stopped to
avoid the transmission system from
being damaged.
Parking brake
Pull the lever up to set the parking brake.
To release the parking brake, raise the lever
slightly and push the button with your thumb.
Then, lower the lever completely.
CAUTION
When you drive the vehicle, make sure that
the parking brake has been completely
released and the brake warning light is
off. A partially applied parking brake could
cause brake overheating, resulting in
prematurely worn pads or linings.
Set
Unlock
Release
Sect 10_EN D42L.indd 12 07/11/2019 8:26 AM
To Next Page
Loading...
