PERODUA Bezza - Page 484

10–16
w WARNING
• Do not get out of the vehicle
during Eco Idle. This could cause
unexpected accidents.
• If you unfasten the driver’s seatbelt
or open the driver’s door, the
engine restarts even the brake
pedal is depressed. Do not panic
but continue depressing the brake
pedal.
• The warning buzzer continues to
sound for 5 seconds, or until the
seat belt is fastened and the door
is closed to the original state.
CAUTION
• During Eco Idle, the engine restarts
if the accelerator pedal is depressed
while depressing the brake pedal. Be
careful when starting your vehicle.
• Before leaving your vehicle or before
parking your vehicle for a long time,
make sure to apply the parking brake
and operate the engine switch to stop
the engine.
For normal operation of Eco Idle
• Eco Idle may not operate normally
under the following conditions. Have
the vehicle checked by an authorised
Perodua Service Centre.
• Seat belt warning light flashes, even
though driver’s seat belt is fastened.
• Seat belt warning light does not
flash, even though driver’s seat belt
is not fastened.
• Door ajar warning light turns on or
interior light turns on even though
the driver’s door is closed or the
interior light switch is in “DOOR”
position.
• Door ajar warning light does not
turn on even though the driver’s
door is opened or the interior light
does not turn on when the interior
light switch is in “DOOR” position.
Precaution for Eco Idle
NOTE
Operation during Eco Idle
• Even if the shift level is moved from D4
range to the N range during Eco Idle,
Eco Idle continues.
Note that if shift level is moved to the N
range before moving it further to other
ranges, the engine restarts.
• When you want to prepare for vehicle
start during Eco Idle (e.g. right or left
turn), you can restart the engine in
advance by the following operations:
• Quickly apply additional force to the
brake pedal.
• Press the Eco Idle OFF switch.
Air conditioner operation during Eco Idle
• During Eco Idle, cooling and
dehumidifying functions of the
air conditioner are stopped. Only
ventilation function is available.
To return to normal operation, restart
the engine by the following steps:
• Quickly apply additional force to the
brake pedal.
• Operate the steering wheel.
• Press the Eco Idle OFF switch.
Sect 10_EN D42L.indd 16 07/11/2019 8:26 AM