11–9
To remove / install the tyre
1. Slacken the wheel hub nuts with the wheel
hub nut wrench.
Do not remove the hub nuts.
w WARNING
Be careful not to get injured by
slipping the hub nut wrench.
Precaution for temporary use spare tyre
(for variant: X & AV)
The spare tyre equipped in your vehicle is
smaller than the standard tyre and is designed
for temporary use only.
w WARNING
• When the front wheel gets a flat
tyre, install the temporary spare
tyre on the rear wheel (rear axle).
Then, install the removed rear
tyre on the front wheel. Ensure to
install the temporary spare tyre at
the correct axle as it influences the
vehicle performance.
• The spare tyre is for temporary use
only. The standard tyre should be
repaired and replaced as soon as
possible.
• Do not drive more than 80km/h with
the temporary spare tyre installed.
• Have the temporary spare tyre
checked regularly. Driving on
a temporary spare tyre with
insufficient pressure may result in
an accident. (See Section 17 for the
specification of tyre pressure)
2. Four jack setting points are provided: two
on each side as shown in the illustration.
Set the jack at the jack setting point that
is nearest to the flat tyre.
Sect 11_EN D42L.indd 9 25/10/2019 11:59 AM
To Next Page
Loading...
