11–16
Cover
Cloth
Flat screwdriver
Towing hook
1. Wrap a cloth or anything similar around a
flat screwdriver and insert it into the groove
of the cover. Then, remove the cover.
2. Insert the towing hook by turning it
clockwise as shown in the arrowheaded
direction until the towing hook is tighten
securely.
A driver must ride in the vehicle being towed
and control it.
w WARNING
• When the engine is not running,
the brake booster does not operate.
Therefore, braking will require more
force than usual.
• For safety reasons, do not use a
towing hook unless your vehicle
is towed on hard-surfaced roads.
• The ignition key of the vehicle being
towed should not be pulled out or
be turned to “LOCK” or “OFF”. The
towed vehicle could lose turning
ability and cause an accident.
To tow vehicle
1. Release the parking brake and shift the
transmission to neutral.
2. Turn the ignition switch to “ACC” with the
engine off, or to “ON” with the engine
running.
Instructions on towing
Sect 11_EN D42L.indd 16 25/10/2019 11:59 AM
To Next Page
Loading...
