15–2
1. Room light
2. Hazard light
2
2
2
1
Operation procedures
Steps:
1. To activate the alarm system, all doors,
trunk and hood must be closed.
2. Press the button 1 of the transmitter once
or press request switch to lock all doors.
The alarm system is “ON” and all doors
are “LOCK”. The hazard light will flash
once and buzzer will sound once.
3. If any of the doors, trunk or hood be opened
by an ignition key or other methods, the
hazard light will flash and room light lights
immediately (room light is set to “DOOR”
position). Then the horn will sound.
4. To de-activate the system, press the
button 2 or press request switch to
unlock driver’s door. The alarm system is
“OFF” and driver’s door is “UNLOCK”. The
hazard light will flash twice and buzzer will
sound twice.
Sect 15_EN D42L.indd 2 24/10/2019 4:30 PM
To Next Page
Loading...
