15–4
Booster
Battery
Weak
Battery
(1) Disconnect
Red
Black
Red
Black
(2) To car chassis
4. Car battery weak-jump start
Avoid “Jump Start” from battery to battery
as this will cause the Alarm System to
be damaged. However, if the jump start
cannot be avoided, the below procedure
must be followed;
disconnect the -ve lead (1) from the weak
battery and connect jumper cable (2) onto
chassis as shown.
1. Pry open the transmitter using suitable
flat screwdriver.
Replacement of battery in the
transmitter
(Type 1)
3. Avoid dropping or exposing the
transmitter to water
a) In the event where the transmitter
is dropped, you may not be able to
activate/de-activate the system. If this
happens, open the transmitter case
and check the contact points of the
battery holder.
b) In the event the transmitter is exposed
to water, dry it before using.
c) If the transmitter still cannot be
operated after (a) and (b) above,
consult an authorised Perodua Service
Centre.
Sect 15_EN D42L.indd 4 24/10/2019 4:30 PM
To Next Page
Loading...
