16–1
Reverse sensor Front corner sensor
(if equipped)
Refer to zone detection
Front corner sensor
location
Zone detection
a) 1.15 meter to 0.8 meter ! buzzer sounds
(5 beep/s)
b) 0.8 meter to 0.5 meter ! buzzer sounds
(8 beep/s)
c) 0.5 meter to 0.1 meter ! Continuous
sound
You should reduce vehicle speed and beware
of those obstacles behind. When the beep
sound change from intermittent to continuous,
the distance between your vehicle rear
bumper and the nearest object behind your
vehicle is less than 0.5 meter. You should
immediately stop your vehicle.
This reverse sensor is designed to guide
drivers reversing and reverse parking. It
should not be considered as a safety device.
The device will start to operate 0.8 second
after the driver engaged the reverse gear
(with engine started).
When the device start generating, an
intermittent beep sound, the distance
between your vehicle rear bumper and the
nearest obstacle behind your vehicle is
approximately:
This front corner sensor will assist the driver to
park the vehicle during front straight parking or
side parking into tight space. The device lets
you know the approximate distance between
the vehicle and obstacles while parking.
The front corner sensors works only when
the ignition switch is turned ON, front corner
sensor switch is turned ON and the vehicle
speed is less than 10 km/h.
Sect 16_EN D42L.indd 1 24/10/2019 4:30 PM
To Next Page
Loading...
