PG DRIVES TECHNOLOGY I-DRIVE TECHNICAL MANUAL – WARNING SUMMARY
1 Introduction
This section summarizes all of the very important warnings that appear throughout the text of this manual. Do not install, maintain
or operate the machine without reading, understanding and observing the following warnings. Failure to observe these warnings
could result in UNSAFE CONDITIONS for the user of a machine or affect the reliability of the controller. PG Drives Technology
accepts no liability for losses of any kind arising from failure to comply with any of the conditions in the warnings listed below.
Failure to observe these warnings will invalidate the i-Drive warranty.
The machine manufacturer may wish to use this section as a checklist, to ensure the risk areas
identified below have been addressed within their own machine designs and associated
documentation.
2 Warnings
2.1 Driving Technique
The machine user must be capable of driving a machine safely. PGDT accepts no liability for
losses of any kind arising from failure to comply with this condition.
2.2 Hazards
Although the i-Drive is designed to be extremely reliable and each unit is rigorously tested during
manufacture, the possibility of system malfunction always exists (however small the probability).
Under some conditions of system malfunction the controller must (for safety reasons) stop the
machine instantaneously. If there is any possibility of the user falling out of the machine as a
result of a sudden braking action, it is imperative that a restraining device such as a seat belt is
supplied with the machine and that it is in use at all times when the machine is in motion. PGDT
accepts no liability for losses of any kind arising from the unexpected stopping of the machine, or
arising from the improper use of the machine or controller.
Do not operate the i-Drive if the machine behaves erratically or shows abnormal signs of heating,
sparks or smoke. Turn the i-Drive off at once and consult your service agent. PGDT accepts no
liability for losses of any kind arising from failure to comply with this condition.
Electro Magnetic Interference (EMI) can affect electronic equipment. Such interference may be
generated by radio stations, TV stations, other radio transmitters and cellular phones. If the
machine exhibits erratic behavior due to EMI, turn the controller off immediately and consult your
service agent. PGDT accepts no liability for losses of any kind arising from failure to comply with
this condition.
It is the responsibility of the machine manufacturer to ensure that the machine complies with
appropriate National and International EMC legislation. PGDT accepts no liability for losses of
any kind arising from failure to comply with this condition.
The machine user must comply with all machine safety warnings. PGDT accepts no liability for
losses of any kind arising from failure to comply with this condition.
SK76977-07 105
To Next Page
Loading...
Need help?
General
