I-DRIVE TECHNICAL MANUAL – OPERATION PG DRIVES TECHNOLOGY
6 Precautions for Use
In the event of the machine moving in an unexpected way, RELEASE THE THROTTLE. This action
will stop the machine under any circumstances.
6.1 Hazards
Do not drive the machine:
Beyond restrictions indicated in your machine user manual, for example inclines, curb heights etc.
In places or on surfaces where a loss of wheel grip could be hazardous, for example on wet grassy slopes.
If you know that the controller or other crucial components require repair.
Although the i-Drive is designed to be extremely reliable and each unit is rigorously tested during
manufacture, the possibility of system malfunction always exists (however small the probability).
Under some conditions of system malfunction the controller must (for safety reasons) stop the
machine instantaneously. If there is any possibility of the user falling out of the machine as a
result of a sudden braking action, it is imperative that a restraining device such as a seat belt is
supplied with the machine and that it is in use at all times when the machine is in motion. PGDT
accepts no liability for losses of any kind arising from the unexpected stopping of the machine, or
arising from the improper use of the machine or controller.
Do not operate the i-Drive if the machine behaves erratically or shows abnormal signs of heating,
sparks or smoke. Turn the i-Drive off at once and consult your service agent. PGDT accepts no
liability for losses of any kind arising from failure to comply with this condition.
Electro Magnetic Interference (EMI) can affect electronic equipment. Such interference may be
generated by radio stations, TV stations, other radio transmitters and cellular phones. If the
machine exhibits erratic behavior due to EMI, turn the controller off immediately and consult your
service agent. PGDT accepts no liability for losses of any kind arising from failure to comply with
this condition.
It is the responsibility of the machine manufacturer to ensure that the machine complies with
appropriate National and International EMC legislation. PGDT accepts no liability for losses of
any kind arising from failure to comply with this condition.
The machine user must comply with all machine safety warnings. PGDT accepts no liability for
losses of any kind arising from failure to comply with this condition.
SK76977-07 14
To Next Page
Loading...
Need help?
General
