I-DRIVE TECHNICAL MANUAL – WARNING SUMMARY PG DRIVES TECHNOLOGY
2.3 Safety Checks
These checks should be conducted in an open space and a restraining device such as a seat belt
should always be used. PGDT accepts no liability for losses of any kind arising from failure to
comply with this condition.
2.4 Pushing Your Machine
Depending on the type of freewheel mechanism, then it may be possible for the machine to
freewheel at potentially dangerous speeds. Therefore, do not push the machine up or down
inclines on which you cannot stop or hold the machine. Never sit on the machine if the freewheel
mechanism is disengaged. PGDT accepts no liability for losses of any kind arising from the
machine being moved while the freewheel mechanism is disengaged.
Do not freewheel the machine faster than the programmed Maximum Speed, e.g. by towing. PGDT
accepts no liability for losses of any kind arising from failure to comply with this condition.
2.5 Programming
Programming should only be conducted by electronic service professionals with in-depth
knowledge of PGDT controllers. Incorrect programming could result in an unsafe set-up of a
machine for a user. PGDT accepts no liability for losses of any kind if the programming of the
controller is altered from the factory preset values.
2.6 Servicing
PGDT accepts no liability for losses of any kind arising from unauthorized opening, adjustment or
modifications to the i-Drive controller.
If the i-Drive controller is damaged in any way, or if internal damage may have occurred through
impact or dropping, have the product checked by qualified personnel before operating. PGDT
accepts no liability for losses of any kind arising from failure to comply with this condition.
The warranty will be void if the i-Drive has not been used in accordance with the i-Drive Technical
Manual SK76977, the i-Drive has been subject to misuse or abuse, or if the i-Drive has been
modified or repaired by unauthorized persons.
2.7 Program Settings
It is the manufacturer’s responsibility to program the control system to suit the machine model
and ensure safe operation in compliance with relevant legal requirements over the whole of the
operating range. PGDT accepts no liability for losses of any kind due to failure to, or incorrect
programming of, the i-Drive controller. Refer to Chapter 3 for details on programming individual
parameters.
Programming should only be conducted by electronic service professionals with in-depth
knowledge of PGDT electronic controllers. Incorrect programming could result in an unsafe set-up
of a machine for the user. PGDT accepts no liability for losses of any kind if the programming of
the controller is altered from the factory preset values. PGDT accepts no liability for losses of
any kind if the drive or stability characteristics of the machine are altered without prior
notification and discussion with PGDT.
SK76977-07 106
To Next Page
Loading...
Need help?
General
