I-DRIVE TECHNICAL MANUAL – OPERATION PG DRIVES TECHNOLOGY
11 Programming
If you cannot find a position on the speed limiting control that suits you, the controller can be programmed to meet your needs.
The controller can be programmed in three ways – with an SP1 programmer, a DTT Programmer or specialist PC software and
interface cable.
The SP1 is a small hand-held unit, which can be plugged into the controller to alter parameter values.
The DTT is PGDT’s latest hand-held programmer. With a larger LCD screen than the SP1, many parameters can be viewed at the
same time. The DTT can also be plugged directly into the controller to alter parameter values.
The PC Programmer contains a software CD and an interface cable. When the software is installed onto a PC, it can then be
connected to the controller by using the special programming cable. The i-Drive can then be programmed in a Windows™ type
environment.
The programming tools may be included with your machine. If they are not, your machine distributor or service agent or
machine manufacturer will be able to program your controller for you.
If you have a programmer, read the user guide before you use it.
If you re-program your controller, make sure that you observe any restrictions given in your machine user manual. Note any
changes you make for future reference.
Programming should only be conducted by electronic service professionals with in-depth
knowledge of PGDT controllers. Incorrect programming could result in an unsafe set-up of a
machine for a user. PGDT accepts no liability for losses of any kind if the programming of the
controller is altered from the factory preset values.
12 Warranty
The i-Drive controller is covered by a warranty period defined by the machine manufacturer. For details of the warranty period,
please contact your service agent.
The warranty will be void if the i-Drive has:
• Not been used in accordance with the i-Drive Technical Manual, SK76977.
• Been subject to misuse or abuse.
• Been modified or repaired by non-authorized persons.
SK76977-07 20
To Next Page
Loading...
Need help?
General
