Philips IntelliVue MX40 - Page 144

WLAN Configuration Parameters
9-4 MX40 WLAN (P/N 865352)
Hardware Wireless WLAN
Parameter
Applicable to
MX40
Available
Selections
Comments
General
WMM Mode Yes Disabled, Enabled To enable QoS, this must be set to
"Enabled", and QoS State on the
Network menu page must be set to
"On".
Security Mode Yes WEP, WPA (PSK),
WPA2 (PSK),
WPAEnterpr,
WPA2Enterpr
WPA2-Enterprise is not
recommended due to increased
handover times.
Mode Yes Auto, 802.11ah,
802.11bg, 802.11g
802.11 ah is recommended.
SSID Yes **** 1-32 characters
WEP
WEP Key Index Yes 1, 2, 3, 4
This selects which WEP Key will be
used.
WEP Key Size 1 Yes 104 Bit, 40 Bit
WEP Key 1 Yes **** 10 or 26 hex characters based on
Key Size
1,2,3,4,5,6,7,8,9,A,B,C,D,E,F
WEP Key Size 2 Yes 104 Bit, 40 Bit
WEP Key 2 Yes **** 10 or 26 hex characters based on
Key Size
1,2,3,4,5,6,7,8,9,A,B,C,D,E,F
WEP Key Size 3 Yes 104 Bit, 40 Bit
WEP Key 3 Yes ****
10 or 26 hex characters based on
Key Size
1,2,3,4,5,6,7,8,9,A,B,C,D,E,F
WEP Key Size 4 Yes 104 Bit, 40 Bit
WEP Key 4 Yes ****
10 or 26 hex characters based on
Key Size
1,2,3,4,5,6,7,8,9,A,B,C,D,E,F
WPA (PSK) / WPA2 (PSK)
WPA Password Yes **** 8-63 characters
WPA Enterprise / WPA2 Enterprise
Authentication Yes
NotConfigrd, PEAP,
TTLS
If WPA / WPA2 Enterprise is
selected, must select PEAP or
TTLS.