Philips IntelliVue MX40 - Assigning an Equipment Label - IIC

Assigning an Equipment Label - IIC
2-6 Installation
Assigning an Equipment Label - IIC
 To assign an equipment label to a device:
1. Select All Controls > Label Assignment.
2. Enter password (tele)
3. Insert battery power into the MX40 and if attached, disconnect the patient
cable.
4. Select Refresh.
5. Confirm the connection to the wireless network as follows:
6. Select the MAC address of the device from the New Devices list. If the
address does not appear, remove battery power and re-insert. Select
Refresh.
Note — The MAC address appears on the rear label of the MX40.
7. Select the desired equipment label from the Equipment Label list.
8. Select Assign Label to initiate programming of the equipment label and
RF Access Code into the MX40.
9. When prompted, press Confirm on the MX40 to accept the assignment. The
confirmation must occur within 30 seconds of the prompt.
10. On the MX40, wait for the New_Device label to change to the selected
equipment label.
11. Confirm the label assignment by viewing the waveform in the Patient
Sector at the Information Center.