WLAN Configuration Parameters
MX40 WLAN (P/N 865352) 9-5
Parameter
Applicable to
MX40
Available
Selections
Comments
Inner Authentication Yes NotConfigrd, PAP,
CHAP, MSCHAP,
MSCHAPv2
The MX40 only supports
MSCHAPv2.
PEAP Version Yes Default, Version 0,
Version 1
PEAP Label Yes Default, EAP, PEAP
Certificate Check Yes Disabled, Enabled
Should be "Enabled" is using a
certificate. "Disabled" is provided for
troubleshooting purposes.
User Name Yes **** 0-63 characters
Password Yes **** 0-63 characters
Anonymous Identity Yes **** 0-63 characters
Certificate 1
Friendly Name Yes **** 0-32 characters
CA Certificate Yes Add, Delete
File Size Yes
Not modifiable, reflects file chosen
Valid from Yes
Not modifiable, reflects file chosen
Valid until Yes
Not modifiable, reflects file chosen
WLAN Configuration Parameter Definitions
Hardware > Network Parameter Definitions
These definitions are for the parameters that apply to the MX40.
WLAN IP Config – these are parameters that apply specifically to the
wireless network adapter.
• "Enabled" under the WLAN IP Config section refers to the wireless
network adapter in the MX40. When "Enabled" is configured "on" the
wireless network adapter is on and active. When configured "Off", the
wireless network adapter is in a low power sleep state.
• "Mode" under the WLAN IP Config section refers to the network
configuration protocol the device uses when communicating over the
802.11 link. Although other selections may be available on the
IntelliVue Support Tool Configuration Editor, the only network
configuration protocol that the MX40 supports is DHCP.
To Next Page
Loading...
Need help?
General
