Monitoring Mode
4-6 Operating Modes
SmartKeys
The following table lists the SmartKeys available on the display of the
MX40.
Note—gray text on a SmartKey signifies that the item is unavailable.
SmartKey Function
Start SpO
2
Note — This
SmartKey is
unavailable when
SpO
2
mode is
continuous.
Starts a manual SpO
2
measurement.
Delayed Record Starts a delayed recording at the
Information Center.
Alarms
Alarm Volume setting. Review of up to 50
previous alarm conditions (entries are
stored during power cycle). Pause Alarms
for configured time period (if enabled at
the Information Center).
Mode: Telemetry /
Mode: Monitor
Toggles between modes. In Telemetry
Mode, display and audio are off; in
Monitor Mode, display and audio are
always on.
Standby
Puts the device into Standby locally and
at the Information Center. Displays
purchased/enabled product options. To
resume from Standby, touch the Main
Screen button.
Add/Remove
Displays available monitors and IntelliVue
Cableless Measurements to assign to via
the short-range radio.
Print Reports
Prints the pre-configured report as
designated at the Information Center.
Trends
View up to 24 hours of tabular and
graphical trend data (Option C03). One
hour tabular trend standard.
To Next Page
Loading...
