Phytec phyFLEX-i.MX 6 - Page 19

Introduction
 PHYTEC Messtechnik GmbH 2013 L-773e_2
3
 Up to 16 MB on-board serial Flash (bootable)
 Up to 4 kB I
2
C EEPROM
 Serial interface with 4 lines (TTL) allowing simple hardware
handshake
 High-Speed USB OTG transceiver
 High-Speed USB HOST transceiver
 10/100/1000 Mbit Ethernet interface
 Two I
2
C interfaces
 Two SPI interfaces
 PCIe Interface
 I
2
S Interface
 CAN interface
 Media Local Bus (MLB) interface
 4 Channel LVDS (24 Bit) LCD-Interface
 HDMI interface
 Two LVDS Camera Interface
 Two SD/MMC card interfaces
 SATA interface
 Support of standard 20 pin debug interface through JTAG
connector
 Eleven GPIO/IRQ ports (with phyFLEX-flex connector even
more)
 Two user programmable LEDs
 Power Management IC (PMIC)
 Optional Environment Management IC (EMIC) to monitor
voltage, current and temperature, and for fan control
 One Wake Up input
 Industrial temperature range (-40 °C to +85 °C)
Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.