Pitco SSH Series - Page 26

PitcoSolsticeandSolsticeSupremeHighEfficiencyGasFryers



SG/SSHSeriesServiceManual 26
8. Disconnect the connection from the valve.
9. Remove the bolt from the pilot, which holds the
ignition ground, using a 5/16 inch open-ended
wrench.
10. Once the entrance box is out, disconnect the
spinal tap connection.
11. Remove one (1) screw using a 5/16 inch socket.
12. Slide metal retaining bracket off.
13. Remove the spinal tap wiring harness from the
grommet.