Pitney Bowes DA80F - Page 195

I-3
Index
DA50S/DA55S/DA70S/DA75S AddressRight™ Printers Service Manual (SV61831 Rev. A)
LCD Setup Menu
Bundle Break A-17
Communications A-13
Conveyor [Stacker] Setup - Output A-12
Feeder Setup - Input [affects DA95F only A-11
Feed Gap A-15
Hex Dump Mode A-19
Ink Cartridge Volume A-15
Language A-14
Lines per Address A-12
Low Ink Warning A-18
Pre-Purge A-16
ROM Revision Number A-21
Stop on Feed Error A-10
Tray Break A-18
Lines per Address, LCD Setup Menu A-12
Lower Sensor(Receiver) Assembly on Standard
Feeder, DA95F
Removal 5-41
Low Ink Warning, LCD Setup Menu A-18
M
Main Controller Board
Connectors 4-6
Diagnostics 4-4
LED Designations 4-7
Removal, DA95F 5-51
Removal. DA80F 5-4
Schematics C-2
Service Callouts 4-5
Voltage Checks 4-8
Maintenance.See Preventive Maintenance
Material (Media) Issues that Affect Feeding 4-14
Material Specifi cations 2-7
Media, Approved 2-8
Media, Unapproved 2-9
Media Belts, DA95F
Removal 5-69
Miscellaneous Issues, Troubleshooting 4-23
Motor/DriveAssembly on Standard Feeder, DA95F
Removal 5-46
Motors
Connections to Main Board 4-5, 4-6
Drive Belt/Motor Assembly Removal, DA95F 5-74
Feed Motor Assembly and Feed Motor Encoder
Harness Assembly Removal, DA80F 5-16
Internal Errors 4-11
LEDs for on Main Board 4-7
Motor/DriveAssembly Removal on Standard
Feeder, DA95F 5-46
Relating to feeding issues 4-16
Running Test via Test System in LCD Sevice Menu
A-24
Testing after updating fi rmware A-33
Theory 3-2, 3-5
Transport Motor Assembly Removal, DA80F 5-18
O
Operating Sequence 3-5
P
Paper
Feed/Jam Issues 4-14
Material Specifi cations 2-8
Print Samples for Troubleshooting 4-12
Supported Envelope/Paper Sizes 2-10
Paper Bottom Sensor Assembly (Receiver), DA80F
Removal 5-9
Paper Sensor and Sensor Bar, DA95F
Removal 5-54
Paper Top Sensor Assembly (Emitter), DA80F
Removal 5-9
PCB.See Main Controller Board
Physical Equipment Specifi cations 2-1
Power-Up Printer Errors 4-9
Power Supply, DA80F
Removal 5-37
Power Supply, DA95F
Removal 5-75
Pre-Purge, LCD Setup Menu A-16
Preventive Maintenance
Exit Idler Rollers 7-2
Feed Deck And Covers 7-2
Feed Rollers 7-2
General Guidelines 7-1
Pan Assembly 7-2
Paper, Exit, and Feeder Sensor 7-2
Print Head 7-2
Printer Architecture 3-2
Printer Error Codes 4-10
Printer Internal Errors 4-11
Print Head
Adjust Printing in LCD Service Menu A-23
Alignment Procedure in Appendix D-1
Cable and Board Removal, DA80F 5-21
Cable and Board Removal, DA95F 5-59
Ink Cartridge Volume in LCD Setup Menu A-15
Ink Count in LCD Main Meu A-9
Ink Usage and Cartridge Specs 2-6
Leveling the Print Head Assembly to Deck, DA80F
6-3
Leveling the Print Head Assembly to Deck, DA95F
6-5