Execution Modes
The CLI contains several execution modes. Users will see different set of commands
under different execution modes. Table 5-1 lists all the execution modes and their
purposes. When users enter a certain execution mode, the corresponding mode prompt
will be displayed automatically on the screen. The mode prompts of all the execution
modes are also listed in Table 5-1.
5-1 List of Execution Modes
Execute mode Description Prompt symbol
Initialize Without login prompt or already
authenticated
>
Enable Management capable %
Configure Configuration capable (conf)#
Interface Interface configure capable (intf-conf)#
Ethernet
Interface
Ethernet Interface configure capable (ethernet-intf-conf)#
ATM Bridge ATM Bridge configuration capable (bridge-atm-conf)#
ATM Description ATM Description configuration
capable
(atm-desc-conf)#
ADSL config ADSL line configuration capable (adsl-intf-conf)#
IPOA config IPoA routed mode configuration
capable
(ipoa-intf-conf)#
Bridge Bridge configuration capable (bridge-eth-conf)#
Access List ACL configuration capable (acl-conf)#
Service Profile User/Line service profile
configuration capable
(service-profile)#
Spectrum Profile User/Line spectrum profile
configuration capable
(spectrum-profile)#
Alarm Profile User/Line alarm profile configuration
capable
(alarm-profile)#
Tca Profile User/Line tca profile configuration
capable
(tca-profile)#
IGMP ACL
Profile
IGMP ACL profile configuration
capable
(igmpacl-profile)#
Rate Limit Profile Rate-Limit Policer profile
configuration capable
(rate-limit-profile)#
Priority List Priority List configuration capable (prio-conf)#
- 208 -
To Next Page
Loading...
