- 310 -
5.10 ADSL Configure Mode Commands
The commands in this section can be executed only in the ADSL Config mode.
5.10.1 line mode carrier
Description Set/Clear xDSL line carrier
Syntax line mode carrier {on | off | oninit}
Parameter None
5.10.2 line mode diagnostic
Description Set/Clear xDSL line diagnostics
Syntax line mode diagnostic {init | off}
Parameter None
5.10.3 line mode force-l3
Description Set force to power management L3 mode or not
Syntax line mode force-l3 {on | off}
Parameter None
5.10.4 line mode mask
Description Set/Clear xDSL line Operational mode mask
Syntax line mode mask {set | clear } <opmode ID>
Parameter
Name Description
<opmode id> The ID of allowed ADSL modes of operation.
Valid values: Use ‘list opmode’ command to
see all the operation modes. Or refer to Table
A-1.
Default value: -
Type: Mandatory
To Next Page
Loading...
Need help?
General