- 334 -
5.14 Priority List Mode Commands
The commands in this section can be executed only in the Priority List execution mode.
5.14.1 ds
Description Set Differentiated Service of packets to remark VLAN priority / Show
Differentiated Service priority list entry / Disable Differentiated
Service priority list entry
Syntax ds <number> prio <prio ID> {xdsl <port>/<pvc> | gigabit <port>} dscp
<dscp>
ds <number> list
ds <number> disable
Parameter
Name Description
<number> Differentiated Service priority list number.
Valid values: 1~256
Default value: -
Type: Mandatory
<prio ID> Priority value
Valid values: 0~7
Default value: -
Type: Mandatory
<port> Port number.
Valid values: 1~24(48) for xDSL, 1 for GBE
Default value: -
Type: Mandatory
<pvc> PVC number
Valid values: 1 ~ 8
Default value: -
Type: Mandatory
<dscp>
Diffserv Code Points, which is a 6-bit number.
The standardized combinations are listed below:
default Default value (bits:000000)
af11 Assured Forwarding Class 1:Low Drop
(bits:001010)
To Next Page
Loading...
Need help?
General