Planet IDL-2402 - Show Vlan Ethertype; Show Vlan Protocol-Base; Show Vlan-Translation One-To-One; Show Vlan-Translation Many-To-One

5.3.117 show vlan ethertype
Description Show VLAN S-Tag Ether type
Syntax show vlan ethertype
Parameter None
5.3.118 show vlan protocol-base
Description Display protocol based VLAN table
Syntax show vlan ethertype
Parameter None
5.3.119 show vlan-translation one-to-one
Description Display one-to-one VLAN translation table
Syntax show vlan-translation one-to-one
Parameter None
5.3.120 show vlan-translation many-to-one
Description Display many-to-one VLAN translation table
Syntax show vlan-translation many-to-one
Parameter None
5.3.121 telnet
Description Telnet to a destination (if you’re connecting to the DSLAM through
its console port, this command is not provided)
Syntax telnet <target address>
Parameter
Name Description
target address IPV4 address or hostname
Valid values: xxx.xxx.xxx.xxx (xxx:0~255)
Default value: -
Type: Mandatory
5.3.122 traceroute
Description Trace route (and not use ICMP ECHO instead of UDP datagrams)
Syntax traceroute <target address> [no_icmp]
Parameter
Name Description
target address IPV4 address
Valid values: xxx.xxx.xxx.xxx (xxx:0~255)
Default value: -
Type: Mandatory
- 245 -