System Protocol Setup – Timer setting
Label Description
Port Authentication section – Timer Setting
Select the line bridge port range to be listed.
Select Port
Remember to select the checkbox when you want to modify/delete the
setting of a bridge port or set a bridge port to its default value.
Supplicant Timeout
Type in the number of seconds our system will wait for a response before
resending the request to the supplicant. Default is 60 (sec).
Server Timeout
Type in the number of seconds our system will wait for a reply before
resending the response to the authentication server. Default is 60 (sec).
Tx Period
Type in the number of seconds our system will wait for a response to an
EAP-request/identity frame from the supplicant before resending the
request. Default is 30 (sec).
ReAuthentication Period
Type in the number of seconds between re-authentication requests. Default
is 3600 (sec).
Quiet Period
Type in the number of seconds that our system remains in the quiet state
following a failed authentication exchange with the supplicant. Default is 60
(sec).
- 81 -
To Next Page
Loading...
