Platan Proxima - Hotel Features

Proxima, Libra firmware ver. 2.12.xx
rev. 2.12.01
70
The programming of external devices control is described in the
ProximaWeb/LibraWeb program operation manual).
Relay access numbers and codes are assigned by server administrator.
4.4.7 Hotel features
Proxima IP PBX Server and Libra PBX Server are compatible with the most
popular hotel software; the list of compatible hotel applications is available on
www.platan.pl website.
Thanks to the cooperation with the hotel application, a user can handle up to 8
room statuses, defined according to the individual needs:
Exemplary room statuses:
1 – room done,
2 – minibar refilled etc.
Room status handling in Proxima/Libra servers is available from the phone:
*766 xxx – saving room statuses, where x is a single room status, e.g. *766135 –
saving status 1, 3, 5 for this room.
*766 #x#x#x – deleting room statuses, where x is a single room status, e.g. *767#1#5
– deleting status 1 and 5 for this room.
Example: *766 1#32#4 – saving status 1 and 2 and deleting status 3 and 4 for a
given room.
1. After dialling the prefix, the user will hear a continuation tone.
2. Dial * or # to specify the type of operation (* – setting status, # – deleting
status).
If you dial any other digit, the PBX server will beep 3 times and you will have
to wait again for * or #.
Dialling * or # will be confirmed with a continuation tone and you will go to
item 3.
3. Dial the status bit number (1-8) to be set. The server produces a continuation
tone and goes to item 4. If you dial a number from outside the range, the PBX
server will beep 3 times and you will go back to item 2.
4. If you dial a correct number, you will hear a confirmation tone and go back to
item 2.