Platan Proxima - Access to the Services Offered by the Server

Proxima, Libra firmware ver. 2.12.xx
rev. 2.12.01
11
2. Access to the services offered by the server
A function access symbol has been introduced in the server. This symbol should
be pressed before the combination of digits responsible for a specific server
function. After the function access symbol has been entered, the numeration range
is expanded and the conflict between the server function codes and its numeration
plan is solved. The user may choose between using a function access symbol and
working in a standard service access mode. The function access symbol is set by
default to “*.”
Types of access to functions:
 standard – access to the server functions is gained by entering the combination
of digits to which certain functions are assigned;
 after entering # – # must be entered before the combination of digits;
 after entering * – * must be entered before the combination;
The above settings do not apply to the functions carried out after pressing the
Flash button, such as for example: transferring internal and incoming external
calls, hold function, etc. Dialling emergency, extension and external numbers
(with the “0” prefix) requires no special symbol as well.
The type of access to the server functions from the phone is defined in the program
(menu: Common settings → Global settings).
Conferences require a special symbol to be used after pressing the FLASH
button, e.g. Flash *7 “TEL.”
The symbol for exiting the Hotline function is defined in the computer
program (menu: Common settings → Global settings). If the symbol for
exiting the Hotline function is the same as the access symbol to the server
functions, the exiting symbol must be entered twice in order for the
function to work.