Proxima, Libra firmware ver. 2.12.xx
rev. 2.12.01
xxx=008 announcement 8; xxx=103 melody 4;
xxx=009 announcement 9; xxx=104 ring-back tone;
xxx=010 announcement 10; xxx=106 routing;
xxx=012 announcement 12; xxx=107 three tones;
Hang up the phone.
The phone will ring with a calling tone. After picking up the phone, the
recorded announcement may be listened to.
The *741xxx function may also be used for independent telephone
volume control if the telephone ringing is too quiet or too loud.
4.5.5 Date and time setting
The current time and date may be set (or corrected) in the server. This may be done
using either the computer program or the telephone. In order to set the date and
time using the telephone, the server access code must be known and the server
programming mode must be activated.
If you want to set or correct the server time and you are in the programming
mode:
Dial
Dial six digits defining the current time.
E.g. to set the time to 13:27:00, the following number should be dialled:
If you want to set or correct the server date and you are in the programming
mode:
Dial
Dial seven digits defining the date: YY MM DD T
e.g.: to set the date to: 2020.06.11 Thursday, the following number
should be dialled:
To Next Page
Loading...