Platan Proxima - Deleting Active Bookings; Special Service Functions

Proxima, Libra firmware ver. 2.12.xx
rev. 2.12.01
75
Where:
20 – year 2020
06 – June
11 – day of the month
4 – Thursday (1 – Monday,... 7 – Sunday)
4.5.6 Deleting active bookings
If all bookings programmed in the server need to be deleted, this operation may be
performed using the telephone. In order to do it, the server access code must be
known and the programming mode must be activated.
If you want to delete all active server bookings:
Pick up the phone.
Activate the server programming mode.
Dial
You will hear a confirmation tone.
Hang up the phone.
All bookings programmed in the server have been deleted.
4.5.7 Special service functions
The server has certain special codes available in the programming mode. These
codes may be useful as far as the server maintenance services or the measurement
purposes are concerned.
In order to use the functions below, the server access code must be known and the
server programming mode must be activated.
1. Generating the 1kHz model signal – code 32
(active until you exit the programming mode)
2. Generating the fax signal – code 33
(active until you exit the programming mode)