Platan Proxima - Announcement Recording

Proxima, Libra firmware ver. 2.12.xx
rev. 2.12.01
72
41 “IP address” # – setting the IP address, e.g. 41 192*168*1*195# (the server
will be reset after programming),
42 “subnet mask” # – setting the subnet mask, e.g. 42 255*255*255*0# (the
server will be reset after programming).
NOTE
After the IP address has been entered using the telephone, the server will
switch to port 80 by default.
4.5.3 Announcement recording
The server makes it possible to record 99 announcements. Total duration of all
announcements: up to 30 hours. In order to record an announcement:
Pick up the phone.
Activate the server programming mode using the telephone.
You will hear a confirmation tone.
Dial XX ,
where XX=01,02...99 stands for the announcement number .
You will hear a continuous tone lasting for approx. 3 seconds.
After the tone, you may record your own announcement.
After the announcement has been recorded, hang up the phone.
Announcement numeration used in the course of recording
1. – announcement 1/Music/wav;
2. – announcement 2/Music/wav;
3. – announcement 3/Music/wav;
4. – announcement 4/Music/wav;
5. – announcement 5/Music/wav;
.
97. – announcement 97/Music/wav;
98. – announcement 98/Music/wav;
99. – announcement 99/Music/wav;