Platan Proxima - Programming Buttons and Leds in the Digital Proprietary Phone

Proxima, Libra firmware ver. 2.12.xx
rev. 2.12.01
87
– enter the number using the keypad and confirm it by pressing the OK
button.
A given record has been added or edited. In order to delete a given record, select
the desired number, press the EDIT button and press the OK button twice. The
record has been deleted.
The global phonebook may also be managed via the User Zone and LibraWeb
computer program. The description can be found in the ProximaWeb/LibraWeb
program operation manual.
5.1.3 Programming buttons and LEDs in the digital proprietary phone
Digital proprietary phones offer the possibility of defining the functions of
programmable keys (speed dialling). In the case of Panasonic digital proprietary
phones, programmable line keys are numbered starting with 1.
In order to programme the line keys and the LEDs ascribed to them:
1. Enter the programming mode by pressing the PROGRAM button.
2. Press the selected key and enter the preview mode. The LED corresponding to
the programmed button will go on. After the button has been pressed once, the
button settings will be shown on the display. After the button has been pressed
twice, the settings of the corresponding LED will be displayed.
3. By pressing the STORE button in the preview mode, you enter the mode in
which you may define the button or LED settings.
a) When assigning the trunk line, you should enter the trunk line number,
e.g. *801*2*3# (3rd port in the trunk line card installed in the second slot
of the first server unit), both for the button and for the LED. The button
will then signal the call traffic (status) within this trunk line.
b) When assigning the extension number, you should enter the selected
user's number, e.g., 110 for the button and 110 for the LED. The button
will then signal the call traffic (line status) for the 110 extension. The
comma mark is entered using the FLASH button.
It is recommended to enter the comma before the number in the button
settings. As a result, a direct, single-button call transfer for a given user
will be possible.
After the correct data has been entered, the server should recognise the extension
number active within the server and confirm the changes automatically.
If this is not the case, confirm the changes by pressing the STORE button.