Plustek SmartOffice PS286 Plus - Page 213

Button Configuration Window Overview 47
All rights are reserved.
scanning a stack of documents by ADF, you may enable this function to check
paper overlap (i.e., 2 or more pages stuck together when being fed through the
ADF).
To prevent multi-feed errors, please follow the instructions in
the Scanner User's Guide to properly load the paper into the ADF.
Global Settings
Click the
Global settings
button to configure settings of
Blank Page
Sensitivity
,
Image Edge Fill
and
Multi-Feed Detection
(This function may or
may not be available depending on the scanner model you purchase.).
Blank Page Sensitivity
Blank Page Sensitivity is used to adjust the
remove
condition of blank pages
that will be scanned into the computer. Sensitivity values are primarily a
measure of blank page. The larger the sensitivity value, the more scanned
pages will be treated as blank pages and removed
. Slide the thumb of the scroll
bar to the right or left, and the current value is shown to the right of the scroll
bar.
Image Edge Fill
When you scan by the
Color Mode
, you may click
button for white edge fill or
button for black edge fill.
When you scan by the
Grayscale Mode
, you may click
button for white edge
fill or
button for black edge fill.
When you scan by the
BW mode
, you may click
button for white edge fill or
button for black edge fill.
Tick the check box of
All side
s
match
, the widths of four sides would be set to
be the same. You may adjust the width by clicking
buttons. If you do not tick
this check box, then you can adjust the width of each side individually.
Multi-Feed Detection
(This function may or may not be available depending on
the scanner model you purchase.)
Choose the processing option for the scanner to perform when a multifeed has
occurred.
Action When Detected