2.32
9850064 R03 - 2021 650 / 850 Matryx Trail Performance / Crossover Snowmobile Service Manual
© Copyright Polaris Inc.
EXHAUST SYSTEM INSPECTION
Inspect the exhaust system as outlined in the Periodic Maintenance Table.
NOTICE
If removing exhaust components, remove the resonator
q
first and install last. Disconnect the Exhaust Gas
Temperature (EGT) Sensor
w
wire connectors when removing resonator. Do not remove EGT from resonator if
replacement is not required.
Disconnect the Exhaust Gas Temperature (EGT) Sensor
e
wire connectors when removing pipe
r
. Do not remove
EGT from pipe if replacement is not required.
1. Inspect springs
t
. Replace if missing, broken, or stretched.
2. Inspect gasket
y
and pipe socket seal
u
. The gasket and socket seal may weep during break-in period. Weeping
should subside after parts take a set.
IMPORTANT
When re-installing the exhaust system, the EGT sensor wires must be tied back to the designated retention points or
wire failure may occur.
MAINTENANCE
To Next Page
Loading...
