7.28
9850064 R03 - 2021 650 / 850 Matryx Trail Performance / Crossover Snowmobile Service Manual
© Copyright Polaris Inc.
DRIVEN CLUTCH INSTALLATION
1. Verify the same number of offset washers / bushings
are installed on the jackshaft that were present when
the clutch was removed.
2. Apply a light film of Polaris Premium Grease to the
jackshaft splines and shaft.
3. Install the driven clutch.
4. Install spacer
q
, float washers
w
and
e
, flat washer
r
, and driven clutch bolt
t
.
5. Torque bolt to specification.
TORQUE
Driven Clutch Bolt:
18 ft-lbs (25 N·m)
PVT SYSTEM
To Next Page
Loading...
